8 Reasons to Choose Our Pneumatic Lift Rod

The universal lift rod is a multi-section telescopic rod independently developed by our company with a cylinder as the core. This product has the characteristics of multi-section synchronous expansion and contraction, high load, high adaptability, low failure rate and low shaking rate. prospect.

Reasons to choose our pneumatic lift rod

✔️Low failure rate

The mast is made of national grade aluminum alloy 6061, 6063 and stainless steel. It is driven by air pressure and has a cylinder inside. The structure is simple, the failure rate is much lower than other driving methods, and it is easy to use and maintain. The other internal structures are complex, and it is easy to cause the phenomenon of wire rope winding. After rising, it is difficult to lower.

The gear and steel wire and other accessories are reduced inside, and the air pressure is used as the power without increasing the weight of the self-weight. For example, the 6-meter electric lifting rod has a dead weight of 80KG, while the 6-meter pneumatic lifting rod is only 30KG, which greatly reduces the damage of the lifting rod to the vehicle chassis.

Pneumatic lift masts have higher requirements for sealing, so the sealing is the best, which can effectively reduce the entry of sand and gravel into the rod body and scratch the surface of the rod body.

Each section is connected by a guide key, and the whole can be prevented from turning at any height.

Since the pneumatic rod adopts a high-sealing protection ring, the mechanical gap between the nodes is very small. When the rod body is raised, it has high stability and is not easy to shake. At present, our company's achievable deflection amount is ≤±30mm. The minimum deflection of other rods is less than or equal to ±200mm

The mast is made of aluminum alloy, stainless steel and other materials, the surface is anodized, anti-corrosion and rust-proof, not afraid of salt water, water immersion, and not afraid of ultraviolet rays. Working temperature range of pneumatic lift rod: -55℃~80℃. The electric lift rod is only -50 ℃ ~ 70 ℃.

The maximum load of the pneumatic lifting rod can reach 500 kg, while other rods are only about 200 kg.

The air pressure lifting rod adopts air pressure lifting, and there is air pressure protection inside the rod body. In case of an accident, there is air pressure buffer protection, and it will not fall directly from a height of more than 10 meters; while other rods are different. Finally, the high load plus the self-weight of the pole body will cause the wire to break easily due to the high load after a long period of use.

For more information about Pneumatic Lift Rod, we are glad to answer for you.